Tuxgraphics on Arduino

This blog will explain how to use tuxgraphics on an Arduino Duamilanove, with enc28j60 ethernetshield.
-------------------------------------------------------------------------------------------------
Are you trying to use Tuxgraphics on an Arduino board?

If so, it probably won't work, cause the tuxgraphics uses 12,5Mhz clocking from the enc28j60.
but there is a simples solution to use tuxgraphics avr on an arduino board with enc28j60 ethershield:

Bend up pin 9 and 10 on avr, solder a wire from avr pin 9, to enc28j60 pin 3.

Then you have a Tuxgraphics on an Arduino board with 5V!!

I flashed the avr with an external USBASP before mounting the avr back on the Arduino board.
The next thing to try, will be to flash the avr from arduino hex uploader with the arduino bootloader intact...

Sorry my english....
Back to top